How to use a bank of 16-inch center anatomy

Schmidt, Bob shows how and why to draw a wall during the building of a standard 16-inch center on Lay-out. When laying a top and bottom of a wall framing a square dish is usually the most appropriate tool. To begin, flush plate upper and lower ends on the tape hook wire. The first measure is 15 4.1 inches on the first page to insert stud. Every measure must be according to 4.3 inch pin marks on Shy typical tape measure. This will give you tips are16-inch center layout. Sixteen-inch center layout are important for several reasons: many construction materials are designed to fit in a 16-inch layout, ie. Insulation, first aid kit and some backup operations on board tile, cut the installation of fencing or other means. Crown, baseboard, must be attached to the draft of these materials. If you are true to the centers by 16 inches, you still really need to make a wall, find the first pin and the rest of the bolts in the wall is always a multiple ofdistance of 16 cm. Another aspect in the design of a wall, match the existing structure as far as floor joist layout order to heat the space channels, pipelines run to electrical wiring plates without walls is the way and save time and money.



http://www.youtube.com/watch?v=2VwXv3x_5k8&hl=en